UNDER CONSTRUCTION
(please check back again later)
You can find a copy of the printed manual here.
Patch #1
FILTER
CUTOFF
FILTER
RESON.
REVERB
SELECT
BASE
FREQ.
FLANGER
LEVEL
FLANGER
DETUNE
DELAY
LENGTH
DELAY
DEPTH
LEVEL INPUT
LEVEL LINE-IN
ENABLE CHECK
UPDATE CHANGE
ENGINE DRONE
OFF CHANGE
ENGINE DRONE
OFF POWER
OFF RADIO
ON RADIO
OFF SD REC.
START SD REC.
STOP PITCH
SHIFT
To activate a function, press IN or OUT button, then tap a key.
Check the information on the display. Some commands only require one tap (for example, enabling & disabling line input), some other will need to do additional action, e.g. to confirm the command (such as power off) or to select an option (adjust input/output levels, tune the radio, etc..).
Commands explained:
| OUTPUT LEVEL | Change the headphones volume. |
| INPUT LEVEL | Change the line-input or FM radio signal level. |
| LINE-IN ENABLE | Enable the line-input. To disable it, use the same command again. |
| CHECK UPDATE | Check for the firmware update file, and if it is present, apply it. |
| CHANGE ENGINE | Change the drone sound engine. |
| DRONE OFF | Switch the drone sound engine off. |
| CHANGE ENGINE | Change the drone sound engine. |
| DRONE OFF | Switch the drone sound engine off. |
| POWER OFF | Power the unit off safely. Follow the instructions on the display. |
| RADIO ON | Enable the built-in FM radio, and if needed, tune it. |
| RADIO OFF | Switch the FM radio off. |
| SD REC. START | Start recording to the SD card. If this command is used again, the file will be split at that point. |
| SD REC. STOP | Stop recording to the SD card. The files will appear in rec/session directory. Depending on your operation system, they might not be visible immediately. If that's the case, please power cycle your unit. |
| PITCH SHIFT | Shift the input signal down by an octave for funny alien voices. This works with line input and FM radio. To disable it, use the same command again. |